THOMSON R7.4, Configuration Manual

Page: 30 / 44

E-DOC-CTC-20080229-0001 v1.0
24
4| Ethernet Bridge and VLANs
Listing dynVLAN membership information
To list the entries of the dynVLAN membership table , execute following command:
When a device with a MAC address from the table is connected to the bridge, an entry is added to the list of
active entries. To display information on the
active MAC entries and their timeout, execute following
command:
Deleting dynVLAN membership entries
To remove a specific entry from the dynVLAN membership table, execute the command
:eth bridge dynvlan delete
.
Following parameter must be specified:
Id : this parameter identifies the entry to be deleted.
To remove all entries from the dynVLAN membership table, execute following command:
Applications
The Flexiport mechanism is based on the dynVLAN membership mechanism. If the Flexiport mechanism is
used in combination with dynamic MAC addresses, even more than four devices can make use of Flexiport.
=>:eth bridge dynvlan list
ID MAC Address VLAN RemVLAN (* = dynamic)
-- ----------- ---------- ----------
50 00:19:b9:2d:0f:c1 data (none)
=>:eth bridge dynvlan actlist
Index ID MAC Address VLAN Interface Timeout
50 0 00:19:b9:2d:0f:c1 data ethport3 92
=>:eth bridge dynvlan list
ID MAC Address VLAN RemVLAN (* = dynamic)
-- ----------- ---------- ----------
50 00:19:b9:2d:0f:c1 data (none)
=>:eth bridge dynvlan delete id=50
=>:eth bridge dynvlan list
ID MAC Address VLAN RemVLAN (* = dynamic)
-- ----------- ---------- ----------
Before you delete an entry, list all entries to obtain the correct identifier of the entry to be deleted.
=>:eth bridge dynvlan list
ID MAC Address VLAN RemVLAN (* = dynamic)
-- ----------- ---------- ----------
50 00:19:b9:2d:0f:c1 data (none)
=>:eth bridge dynvlan flush
=>:eth bridge dynvlan list
ID MAC Address VLAN RemVLAN (* = dynamic)
-- ----------- ---------- ----------