3
•
Connect it to the DC input of power inserter; and plug the AC
end to an AC Outlet. (Please note that use only supplied power
adaptor.)
•
Switch on the TV (and the set-top box, if present).
•
Check the reception quality. If the reception quality is not good,
adjust the position or angle of the antenna.
5.2 Powering the antenna with the set-top box or digital
TV (fig. 2)
•
Take the coaxial cable that attached on the antenna, and connect
it to the antenna input connector of your Set Top Box (or Digital
TV).
•
Please make sure the antenna powering function of your Set Top
Box (or Digital TV) is activated.
•
Turn on the power switch on the rear panel.
•
Check the reception quality. If the reception quality is not good,
adjust the position or angle of the antenna.
5.3 Wall mounting (fig. 3)
Attach the Wall mounting unit to the back of ANT1410/ ANT1415.
Please use the hook, screws and anchors to fix the antenna on the
wall.
Note
•
Before mounting, check that the wall you have chosen is suit-
able for the weight to be mounted Also make sure that there
are no electric, water, gas or other lines running through the
wall at the mounting site.
•
After the product has been mounted, check that it is
sufficiently secure. You should repeat this check at regular
intervals.
5.4 Setting up the antenna on a table, cabinet or similar
(fig. 4)
Attach the provided stand to the rear of the antenna. Next, place
the antenna on an even surface such as a table or entertainment
stand. Check the reception quality. If the reception quality is not
good, adjust the position or angle of the antenna.
6. Trouble shooting
If you cannot get the digital programs as you expect. Please check
the following conditions:
•
Make sure the power switch on the rear panel is turned on.
•
Check the connection. Make sure all the connection is correct.
•
Check the antenna powering (coaxial cable powering) function of
your STB. ANT1410/ ANT1415 is an active antenna so
you will need to enable the antenna powering function. (Please
check the operational manual of the STB or TV.)
•
If you place the ANT1410/ ANT1415 antenna on the TV panel,
please try to move the antenna away from the TV panel. Some
panel may reduce the signal reception of the antenna.
•
Adjust the direction and position of antenna to find the best
reception angle.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do
not use aggressive cleaning agents.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operat-
ing instructions and/or safety notes.
9. Service and Support
Please contact Hama Product Consulting if you have any questions
about this product.
Hotline: +49 9091 502-0 (German/English)
Further support information can be found here:
www.hama.com
10. Recycling Information
Note on environmental protection:
After the implementation of the European Directive
2012/19/EU and 2006/66/EU in the national legal system,
the following applies: Electric and electronic devices as
well as batteries must not be disposed of with household
waste. Consumers are obliged by law to return electrical and
electronic devices as well as batteries at the end of their service
lives to the public collecting points set up for this purpose or point
of sale. Details to this are defined by the national law of the
respective country. This symbol on the product, the instruction
manual or the package indicates that a product is subject to these
regulations. By recycling, reusing the materials or other forms of
utilising old devices/Batteries, you are making an important
contribution to protecting our environment.
11. Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the radio
equipment type [00132187, 00132188] is in compliance
with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet
address:
www.hama.com->00132187->Downloads
www.hama.com->00132188->Downloads
