11
EN
EN
www.mythomson.com
VIDEOPHONE SMART CONNECT
C - INSTALLATION
4. Swipe the - badge (red), a long beep confirms
the end of the programming of administration
badges.
2.2.2. Add one or more user badges
1. Swipe the badge - (blue), 4 long beeps confirm
activation of programming mode.
2. Swipe all user badges (grey) to be activated,
a short beep confirms, for each badge
presented, that it has been programmed.
3. Once all the badges have been programmed,
wait for 10 seconds. One long beep confirms
the end of the programming process.
2.2.3. Remove one or more user badges
1. Swipe the - badge (red), 4 long beeps confirm
activation of programming mode.
2.
Swipe all user badges (grey) to be
deactivated, a short beep confirms, for each
badge presented, that it has been cleared of
any programming.
3. Once all the badges have been cleared of any
programming, wait for 10 seconds. One long
beep confirms the end of the programming
process.
2.2.4. Remove all user badges
1.
Swipe the administrator badge (yellow),
4 short beeps indicate activation of
administration mode.
2. Swipe 1 user badge (grey) that has been pre-
added to the system, a short beep indicates
that all the user badges have been cleared of
any programming.
2.2.5. Use of badges
To open the electric strike plate, quickly swipe
your pre-programmed grey user badge on the
RFID reading field. One short beep confirms the
opening of the electric strike plate.
To open the gate motor, hold the badge in front
of the RFID scan area for 3 seconds. Two short
beeps indicate that the gate is opening.
2.2.6. Replacing a badge
RFID badges do not have predefined functions.
It is the programming step that sets the badge’s
function.
Badge colours simply enable users to
recognise their function. If a badge is lost, it can
be replaced by any other badge by repeating the
programming step.
3 - INSTALLING THE INTELLIGENT BRACKET
• The smart stand is magnetically attached to the
back of the monitor. To gain access, please slide
the support down.
•
Position the bracket in the chosen location
and check that it is in the optimum position for
connecting the cables.
• If the cables do not emerge directly from the wall,
break off the bottom plastic part.
Summary of Contents for 512269
Page 6: ......
