4
H-belt
Item code: 6629
Butterfly / chest harness
Item code: 6616 (S), Item code: 6617 (M), Item code: 6717 (L)
Butterfly / chest harness, flexible
Item code: 6385/2 (S), Item code: 6585/2 (M)
Seat waistcoat Item code: 6631 (S), Item code: 6632 (M), Item code: 6731 (L)
Cut the backrest padding in the quilted seam depending on the desired moun-
ting height or open the backrest padding flap. Pull the zip down to open the
padding, unhook and release the hook and loop fastener.
Pass the two upper belts through the holes in the upholstery and insert them
into the front back plate.
To facilitate mounting pull the back plate out slightly. For this, loosen the two
knurled screws at the back.
Insert the belts into the cam buckles and adjust the desired belt length (fig. 1).
Reclose the backrest padding flap with the hook and loop fastener. Adjust the
desired back height and retighten the knurled screws.
The two bottom belt ends can be attached with cam buckles to either the back
plate or the plastic element at the side (fig. 2-3). Guide the belts left and right
next to the back upholstery to the corresponding cam buckle and fix them.
TIP:
The belt length can also be adjusted from the front. Pull the D-ring to shor-
ten the belt.
Summary of Contents for tRide
Page 2: ...2 2 3 1 ...
