13
SAR 460 SA G
1
2
1
D
7.2 - Blade-guide blocks
Blade-guide adjustment was made at the factory during the
machine testing. The blade is kept perpendicular to the
workpiece by means of CARBIDE blade-guide pads. Ensure
that knob (1) is completely screwed up against the block.
Periodically check wear status of the pads; also keep the block
and the pads clean.
- The bearings guide the blade to the pads providing the
necessary inclination and reducing the torsion stress of the
blade; they do not need any adjustment or particular care.
- Adjust the blade-guide arm as follows:
Release both knob (1) and handwheel (2).
Position the arm according to the workpiece dimensions;
ensure that it doesn't hit the bench vice.
Fix both handwheels (1) and (2).
-
ATTENTION: Make sure that the limit switch ( D ) stops the
blade-guide arm just before the working table.
The blade-
guide arm should not fall against the working table !!. The
reference screw ( E ) can be adjusted for this purpose.
E
Summary of Contents for SAR 460 SA G DIGIT
