49
[+48V]
LED
This LED is lit when the phantom power is on.
50
[+48V]
switch
When this switch is in ON position, a phantom voltage of 48 V is present at the XLR sockets in the mono channels for
using condenser mics. If no condenser mics are used, the switch should be in the OFF position. The phantom voltage
must not be switched on if an unbalanced XLR cable is connected to one of the MIC inputs.
51
[POWER]
This LED shows that the unit is turned on.
52
[LEDs]
These LED chains indicate the level of the sum signal. Keep the level within a range below +18. The red LEDs indicates
overload. In this case, pull back the two master faders so that the red LEDs do not light up any more.
If the PFL button is pressed in one of the channels, the signal in this channel is displayed in the left LED chain, regard-
less of the channel fader.
53
[PFL]
This LED lights up when in at least one of the channels the
[PFL]
button is pressed and thus the LED chains do not
display the sum signal.
54
[CR & PHONES]
Rotary control to adjust the level at the outputs
[CR OUT]
and
[PHONES]
.
55
[L MIX R]
Master fader to adjust the sum level at the outputs
[MAIN OUTPUT]
,
[CR OUT]
and
[PHONES]
.
Connections and controls
xmix 1202 FX USB
15