thomann TWS 16 HT, User Manual

Page: 25 / 48

Connect one of the audio outputs of the receiver to your mixer or amplifier. Make sure that
only one of the two outputs of the receiver is used at the same time. Otherwise, interferences
can by caused.
First adjust the volume control (6) as follows:
n If you use a microphone input of your mixer, turn the knob to about 1 o'clock. The audio
level at the output sockets will be about 77 mV.
n
If you use a line input of your mixer, turn the knob clockwise to the right stop. The audio
level at the output sockets will be about 770 mV.
In order to achieve optimal sound quality, a fine adjustment may be required.
4.3 Transmitter
Unscrew the lower housing part of the hand-held microphone and open the cover of the bat‐
tery compartment (20) by lifting the clip. Insert the batteries. Pay attention to the correct align‐
ment of the poles. Close the battery compartment and refit the lower housing part by tight‐
ening the screw. Then switch on the transmitter.
Hooking up audio connections
and starting up
Inserting batteries into the
transmitter
Installation and starting up
TWS 16 HT
25