thomann The t.mix 20.12, User Manual

Page: 12 / 32

10 [System / Load Save]
Opens the system menu and the menus for loading or saving presets one by one
11 [Selected Channel]
Level meter for currently selected input channel.
12.13 [AUX / AUX 1-4 / Meters] , [AUX / AUX 5-8 / Meters]
Level meters, switchable between the buses AUX1…AUX8 with the respective buttons.
14 [Solo / Clear]
Cancels the solo mode for all input channels and buses. The button lights when at least one channel or bus is oper‐
ating in solo mode.
15 [AUX / Solo / Meters]
Switches the level meter [Main – Solo] on the top right between Main and Solo.
16 [Assign Channel To Main]
Assigns the currently selected channel or bus to the Main output.
17 [Volume Controller]
Motor fader to adjust the volume of the currently selected channel, bus or DCA group.
18 [AUX Sends 1-8]
Allows the assignment to outputs (routing) for the respective bus.
19 [Mute]
Mutes or unmutes the respective channel.
20 [Pan]
When the pan function is switched on (button [Pan] lights up), use the rotary control [Parameter Adjust] to set the
position of the signal in the stereo panorama. When Pan is off, the rotary knob [Parameter Adjust] controls the
volume of the currently selected channel.
21 [Solo]
Assigns the currently selected input channel to the solo bus.
22 [Control Room]
Volume control for the control room output
23 [PFL]
Switches the Control Room output between the modes Pre Fader Listen (PFL) and After Fader Listen (AFL). This can
be used to monitor a signal either as it is present at the input or as it sounds affected by the tone and volume
controls.
24 [Gate / Comp]
Opens the ‘Gate’ page for Noise Gate settings or the ‘Comp’ page for compressor settings.
25 [Assign / Channel]
Opens the ‘Assign’ page for assigning input channels to buses or the ‘Channel’ page for a summary of the settings
of the currently selected channel, bus, or DCA group.
Connections and controls
mixer
12