thomann STAIRVILLE LS-300, User Manual, Page: 15 / 24

1.
Unfold the feet of the stand until the cross braces are in a horizontal position.
2.
Fix this position with the safety screw on the slider to which the three feet are attached.
3.
If you want to install a truss beam: Loosen the safety screw on the mounting for the truss
beam at the top end of the stand, attach the TV spigot (28 mm adapter) and tighten it
with the locking screw at the mounting; put on the truss beam and fix it in the desired
position with the wing nut. Affix up to six spotlights to the truss beam. Spread the spot‐
lights evenly on the truss beam. Observe the instructions of the respective manufac‐
turers. The maximum load capacity of 45 kg in total must not be exceeded.
If you're not using a truss beam: Attach a spotlight on the stand head.
4.
Loosen the two screws on the extension tubes.
5.
Pull out the upper extension tube to the desired height and fix the position of the upper
extension tube with the locking screw at the upper tube clamp.
6.
Pull out the lower extension tube to the desired height and fix the position of the lower
extension tube with the locking screw at the lower tube clamp.
7.
Push the safety bolts at the upper and lower tube clamp in the respective hole of the
extension tube.
Setting up
Operating
LS-300
15