Congratulations on buying an approved quality product meeting international
standards. The sensor reliably alerts you in case of narcotic gas attacks or gas
leaks. The dynamic temprature compensation and the continuous sensor self
test ensure a reliable operation even under different climatic conditions. In case
of an gas alarm, the unit sends a signal to the WiPro main unit which activates
the siren and indicators immediately. In Case of a gas alarm the WiPro will sound
even in disarmed state. When using solvents, cleaning agents or similar sub-
stances near the Gas detector, switch off the gas detector to avoid unintended
activation of the alarm.
Wireless connection to main unit / range test:
Activate the learning mode as described in the WiPro resp. C.A.S. installation
manual and switch on the gas alarm by pushing Button A. The WiPro main unit
will acknowledge the reception by a single sound. Repeat this procedure on the
selected mounting place of the gas alarm to make sure, the main unit is able to
receive the signal.
Mounting locations:
Choose a location underneath the sleeping-places. Avoid vicinity to heater out-
lets and lead-acid-batteries. The sensor is not to be used in bathrooms. Before
mounting carry out a range test. Switch on the unit while WiPro is in diagnosis
mode. If received the WiPro main unit will confirm by a single sound.
Minimum seperations:
Heater outlets
1,5 m
Lead-acid-batteries
1,0 m
Installation:
Mount the sensor to a wall or closet using the drilling template
(Scetch 2) and the provided screws. !!!Attantion!!! screw in depth
(scetch 1)!!! Plug the connection cable in the socket until it locks audible. You
can lay the cable either through the wall or the small predetermined breaking
point underneath the pushbutton (A).
Interconnections:
Connect the cable to an appropriate powersupply (12/24VDC)
brown
+ 12V/ 24V
white
GND (-)
green
not used
English
