ThinkRF WSA5000 Series, Programmer'S Manual, Page: 47 / 101

SCPI Command Set
Syntax :SYSTem:CAPTure:MODE?
Parameter None
Response BLOCK | STREAMING | SWEEPING
Output Data Type Character
*RST State BLOCK
Example
:SYST:CAPTURE:MODE?
:SYSTem:COMMunicate:LAN:APPLy
This command will apply the changes to the LAN settings and the embedded system will
automatically reconfigure the Ethernet to put in effect the new LAN setting. Once the
LAN settings are applied, they are not affected by power-on,
:STATus:PRESET , or *RST.
Caution: When changing from DHCP to STATIC mode, this command should to be sent
only when all the required LAN settings are set using the appropriate
:SYSTem:COMMunicate:LAN commands.
Syntax :SYSTem:COMMunicate:LAN:APPLy
Parameter/Response None
*RST State N/A
Examples :SYST:COMM:LAN:APPLY
:SYSTem:COMMunicate:LAN:CONFigure
The set command will store the new LAN configuration type to be applied to the WSA.
This command does not take effect until
:SYSTem:COMMunicate:LAN:APPLy is sent
(please refer to the Caution note of the :APPLy command). Once the option is applied, it
is not affected by power-on,
:STATus:PRESET , or *RST.
The query will return the option set or that of the actual current configuration if one is not
set. The CURRENT query will return what is currently and actually used by the WSA's
LAN interface.
Note: *RST command cannot be used to set the box to its manufacturing default state of
DHCP. To set the box back to DHCP from a working STATIC mode, use this command
or the web-browser as mentioned in the WSA User's Guide.
Syntax SYSTem:COMMunicate:LAN:CONFigure DHCP | STATIC
SYSTem:COMMunicate:LAN:CONFigure? [CURRENT]
Parameter Set: DHCP | STATIC
Query: [CURRENT]
Response DHCP | STATIC
I/O Data Type Character
*RST State N/A
Examples :SYST:COMM:LAN:CONF DHCP
:SYST:COMM:LAN:CONF? CURRENT
ThinkRF WSA5000 Wireless Signal Analyzer Programmer's Guide 47