3.4 Remote Controller
Charge
Forward
Right
Back
Mute
Edge
Zigzag
UV
Speed
Spot
Auto
Left
Power
Power Indicator
Power
Power Button
Power Indicator
Press any button, if this indicator lights, it
means the remote controller works.
Charge
Press this button, the robot will look for the
charging base to recharge.
Auto
Press this button, the robot will enter into
auto cleaning mode.
Spot
Press this button, the robot will enter into spot
cleaning mode.
Mute
Press this button to exchange between normal
cleaning mode and mute cleaning mode
Edge
Press this button, the robot will enter into
edge cleaning mode.
Speed
Press this button to adjust the cleaning speed.
UV
Press this button to turn on/off UV sterilization
function.
ZigZag
Press this button, the robot will enter into
zigzag cleaning mode.
3.5 Remote Controller Battery Installation
1. Lift the clasp on the back of remote controller and open the battery cover.
2. Load 2 x AAA alkaline batteries (Pay attention to the correct polarity).
3. Close the battery cover.
NOTE: If not used for a long time, please remove the batteries.
3.6 Pairing Robot with Remote Controller
Ensure that the power switch is off.
Press and hold CHARGE button on remote
controller, then turn on the power switch.
After hearing two beeps, it indicates that
robot and remote controller are paired.
TIP: One remote controller is only able to control one robot. Please make sure the robot
works correctly first, then try to pair the robot with the remote.
10
