5
4
No wireless signal
Your thermostat is not
connected to your modlet.
Move the remote closer to
your modlet and the SET TO
temperature
should reappear.
Low Battery
You need to change the
batteries in your remote with
2 new AAA batteries.
Demand Response Mode
Your window A/C is receiving
a signal to turn off or use a
higher SET TO temperature.
To exit demand response
mode just press the toggle
up ( ) or down (-) button to change the SET
TO temperature.
Normal Operation Mode
Current room temperature
is displayed on top and the
programmed (SET TO) tem-
perature is displayed on the
bottom. To change the target
temperature, press the ( ) or (-) button on the
remote to raise or lower the temperature.
Hardware
modlet
smartAC thermostat
modlet
USB gateway
smartAC thermostat
Red LED light
3-pin wall outlet
modlet button
Power
LCD Display
screen
Toggle up
Toggle down
Menu
Features
LED light status
Light not
on
Solid red
Spinning
clockwise
Slowly fills up
normal operation
mode
circuit overloaded;
unplug one or
more devices
modlet is joining
the network; occurs
when you first set
it up
Each segment will fill up
one at a time until the light
is solid red, then each
segment will turn off; occurs
when modlet is trying to
pair with the thermostat
Receptacle for
A/C unit
Use the wireless thermostat to set a target temperature for your room
and monitor the current room temperature. Please note, after a few
minutes of inactivity the remote enters a sleep mode and the screen
goes blank. To wake up the remote, press any button once.
Press the menu button once and then use the /
- buttons to switch
between Fahrenheit and Celsius.
