ThingMagic Mercury6e M6e-30dBm, Hardware Manual

Page: 16 / 78

Hardware Interfaces
16
Hardware Overview
Hardware Interfaces
Antenna Connections
The M6e supports four monostatic bidirectional RF antennas through four MMCX
connectors: labeled J1 through J4 on the module. See
Cables and Connectors
for more
information on antenna connector parts.
The maximum RF power that can be delivered to a 50 ohm load from each port is 1.4
Watts, or +31.5 dBm (operation above 30dBm requires a professional installer).
Note
The RF ports can only be energized one at a time.
Antenna Requirements
The performance of the M6e is affected by antenna quality. Antennas that provide good
50 ohm match at the operating frequency band perform best. Specified sensitivity
performance is achieved with antennas providing 17 dB return loss or better across the
operating band. Damage to the module will not occur for any return loss of 1 dB or
greater. Damage may occur if antennas are disconnected during operation or if the
module sees an open or short circuit at its antenna port.
Antenna Detection
To minimize the chance of damage due to antenna disconnection, the M6e supports
antenna detection. Detection can be done automatically or manually, the choice of which
is configured through API calls. Regardless of how it’s used it is generally recommend
that antenna detection be enabled as it helps protect the module from possible damage
due to return losses less than 1 dB.
Digital/Power Connector
The digital connector provides power, serial communications signals, shutdown and reset
signals to the M6e module, and access to the GPIO inputs and outputs. These signals are
provided through connector part number:
Molex 53261-1571
- 1.25mm pin centers, 1