© Adolf Thies GmbH & Co. KG · Hauptstraße 76 · 37083 Göttingen · Germany
021821/08/21
Tel. +49 551 79001-0 · Fax +49 551 79001-65 · [email protected] ·
Page 28 of 102
Note:
If possible, the DLU should be operated with a static IP address.
Caution:
The data logger DLU only uses the IPv4 format for the IP address! That means, 4
numbers between 0 and 255, separated by a point e.g. 192.168.7.74.
Caution:
The data logger DLU must be restart after the IP settings, before the changes
become active!
Note:
The DLU can only be addressed in the Ethernet with an IP address valid for the network.
4.5.3.1 Connecting with a dynamic IP address assignment
At delivery DHCP is active in the data logger DLU, i.e. the server assigns its network settings
to the DLU (IP address, subnet mask, gateway). Most networks are set up in such a way that
the IP address is assigned automatically via a DHCP service. Contact your network
administrator for more information.
If your network supports DHCP, do the following:
•
Set a physical connection to the network using a LAN cable.
•
Start the DLU
•
After starting the DLU, use the arrow buttons on the DLU display to go to the map for
the IP settings and check the settings.
•
It is important that DHCP is set to one.
•
Approx 3 minutes after starting, the DLU shows the new IP address that the DLU
received from the DHCP server.
•
After the automatic IP assignment, the connection can be tested (see Section 4.5.2).
13/17
IP-adress : 192.168.000.105
Subnet mask: : 255.255.252.000
Gateway :192.168.004.027
DHCP : 1
Figure 18: Map IP settings
