5 Installation
Attention:
Storing, mounting and operation under weather conditions is permis-
sible only in vertical position, as otherwise water can get into the in-
strument.
Remark:
When using fastening adapters (angle, traverses, etc.) please take a possible ef-
fect on the measurements by turbulences into consideration.
Caution:
The device may only be supplied with a power supply of the
"Class 2, limited power”.
5.1 Wind Vane Mounting
Before the wind direction transmitter can be installed at its selected site, the wind vane must be
mounted on the housing.
Tools:
Not required
Procedure
1. Remove wind transmitter housing from
the packing.
2. Remove cap by counter-clockwise rota-
tion.
3. Remove wind vane from the packing
4. Mount the wind vane on the housing acc.
to figure.
5. Wind vane rotate until it falls into the
guide.
6. Put the cap on the thread, and tighten it
manually by strong clockwise rotation.
Please do not use tools.
Remark
The wiring must be prepared so far, that plug and cable have been pushed through instrument car-
rier, mast, traverse etc., and can be connected to the wind direction transmitter at the moment of
the ”Mechanical Mounting”, described in the following (please refer also to chapter 5.4).
6 - 22
021754/05/14
