THIEMAN TopLifter TT-15, Manual

Page: 7 / 32

7 .
ΧΝ ΜΝΣ
ΝΕΕ Β∆ΜΣ∆Θ ΚΝ≅Χ
∋ϖξ εθνλ σθτβϕ(
ς≅ΘΜΗΜΦ
Ξ∆Ρ
ΧΝ ΜΝΣ
ΝΕΕ Β∆ΜΣ∆Θ ΚΝ≅Χ
∋ρηχδ σν ρηχδ(
ΦΘΝΤΜΧ
ΦΘΝΤΜΧ
Ξ∆Ρ
ΜΝ
ΧΝ ΜΝΣ
κνχ νθ τµκνχ
εθνλ θλο δµχ νε οκσενθλ
ϖησγ οκσενθλ νεε φθντµχ−
3560/4/Φ
ΜΝ
Ξ∆Ρ
ΜΝ
ΟΚ≅ΣΕΝΘΛ
Θ≅ΛΟ
ΟΚ≅ΣΕΝΘΛ
ΝΕΕ
ΦΘΝΤΜΧ
ΓΗ∆Λ≅Μ
An improperly positioned load can overload the liftgate and result in sudden liftgate failure and/
or increased risks to personnel of being hit or crushed by loads. IMPROPERLY POSITIONED
LOADS MAY RESULT IN SERIOUS PERSONAL INJURY AND/OR DEATH. Always position
loads properly on the liftgate platform. Follow information below on how to position loads
properly.
POSITION LOADS PROPERLY ON PLATFORM
NEVER off-center the load on the platform, from side to side or away from truck as this
may overload the liftgate. The center of weight of the load should NEVER be placed beyond
the center of the platform load surface, away from truck. Loads should be placed close to the
platform edge nearest truck. If a load is not uniformly distributed, then the heaviest portion
should be closest to the edge of the platform nearest the truck. NEVER allow any part of the
load to extend beyond the edges of the platform’s flat load surface. NEVER allow any part of
the load to extend over or on, the tapered ramp portion of the platform unless the platform is
lowered completely to the ground and the ramp is supported by the ground.
!
WARNING
FIG. 1
DO NOT OVERHEAT THE HYDRAULIC PUMP
Exceeding the duty cycle of the hydraulic pump, can overheat many components,
including the gear pump, the hydraulic motor, the motor start solenoid, valve coils, etc., and
significantly shorten the expected life of these components. In extreme cases, immediate
damage to the pump or related components may occur. Refer to the Thermal data below.
THERMAL DATA: To avoid overheating the motor do not operate this unit for more than 5
cycles/ 10 minutes with the maximum load. The motor then must be allowed to completely
cool down to ambient temperature before cycling the lift again. This unit also has a 10% duty
cycle, which means the liftgate can be cycled no more than 2 cycles/10 minutes constantly
with the maximum load.