THIEL Outriggers are used instead of normally mounted stabilizer feet to provide
greater stability. They are attached to the bottom of the speaker cabinets with
four mounting bolts screwed into the four threaded openings normally used for
the stabilizer feet. The 4 stabilizer feet shipped with the speaker are then used
as the feet of the outriggers.
Installing Outriggers
Place the speaker on its back with the bottom of the speaker propped an inch or more off the
ÁRRU,IVWDELOL]HUIHHWDUHLQVWDOOHGUHPRYHWKHP
Mount a long strut to the front of the speaker with the ends curving forward and the recesses
at the ends pointing downward by using two of the included bolts into the speaker’s front
VRFNHWV8VLQJWKHSURYLGHGKH[ZUHQFKWLJKWHQWKHEROWVZHOODERXWLQOEWDNLQJFDUH
QRWWRRYHUWLJKWHQ
8VLQJWZRRIWKHLQFOXGHGEROWVWRVHFXUHLWPRXQWDVKRUWVWUXWWRWKHUHDURIWKHVSHDNHUZLWK
the ends curving backward and the recesses at the ends pointing downward.
Remove the locknuts from the feet and store them. Thread the feet completely through the
threaded holes in the outrigger struts from the bottom. Install the caps over the exposed
threads on the top of the struts.
:LWKWKHVSHDNHUVWDQGLQJYHUWLFDOO\LQLWVÀQDOORFDWLRQORRVHQDOOIRXUFDSVDQGWKHQWKUHDG
RQHRUPRUHIHHWGRZQZDUGXQWLOWKHVSHDNHULVVLWWLQJÀUPO\RQWKHÁRRUDQGGRHVQRW
wobble when pushed slightly from any direction. Then tighten all four caps.
THIEL CS3.7
Outrigger
Installation Instructions
THIEL
1DQGLQR%RXOHYDUG/H[LQJWRQ.<7HOHSKRQH)D[
(PDLOPDLO#WKLHODXGLRFRPZZZWKLHODXGLRFRP
CS3.7 with outriggers installed
Locknut
Cap
Rear Strut
Front Strut
Strut Recess
Bolt
Foot
Questions? Contact THIEL’s service department
via email at [email protected] or call
859-254-9247 M-F, 8:30 am- 5:00 pm ET.
