28
VLC-3 rev.04
VLC-3
9.2.2 Light Peak
Peak #:
Light peaks are numbered from 1 to 20 for each period. The
display shows
PE . 1
where 1 (flashing) is the light peak number. If no
light peaks have yet been entered in the controller, the user must start
by entering light peak 1. Otherwise, the user can select the light peak
using the adjustment knob. If you turn the adjustment knob past the
currently defined light peaks, the program will jump to the dusk-to-dawn
programs. You can backtrack by turning the knob in the opposite
direction.
67(3
Press the push-button to step to the state.
State:
The program state is used to signal the end of the light peaks. As
long as the state is ON, the user can continue adding light peaks. When
a light peak is turned off, the user exits the light peak cycle and enters a
new period. The current state of the light peak flashes on the display.
Use the adjustment knob to set the state.
67(3
If the state is ON, push the push-button to step to the start time.
Otherwise, push the push-button to step to the next period (see
First Day of period).
If this is the last period (i.e. the Last Day of Period entered is 365),
programming mode is exited.
Start time:
The start time is entered as a clock time. The hours value
flashes on the display. Use the adjustment knob to set the hours. Press
the push-button. The minutes flash on the display. Use the adjustment
knob to set the minutes.
67(3
Press the push-button to step to the duration.
PE
