14
SERVICING
4. Control replacement
Hob controls
Disconnect from gas supply (1). Remove hob surface (2). Unscrew the corresponding
pipe and thermocouple and remove from the control.
Open the oven door and unscrew the 2 screws holding the thermostat probe in position
and push the probe back out through the hole in the rear of oven. Remove the retaining
screws from on top and underneath the control. Disconnect the inlet pipe and two
burner supply pipes. Remove the fittings off the old control and fit on the replacement.
Oven and Grill control
As above instructions but remove appliance from housing to gain access to the oven
thermostat, grill and oven thermocouples.
5. Remove the grill burner
Disconnect from gas supply (1). Remove appliance from housing (3). Remove hob
surface (2). Remove the two screws retaining the heat deflector. Remove the insulation
wrap and remove the three grill flue retaining screws
– two beneath the fascia panel,
one located on top rear of flue cover. Lift off the flue cover. Lever off starlock washers
retaining the grill burner.
6. Spark Ignition (where fitted)
Disconnect from gas and electricity supply (1). Remove appliance from housing (2).
Grill burner
–
At rear of appliance remove the screw from the bracket and spark ignition
probe. Trace the electrode wire back to the generator and pull off the connector.
Oven burner -
Trace the electrode wire up the back of the cooker to the generator and
pull off the connector. Unscrew the fixing screw on the spark electrode inside the oven
cavity, then carefully pull the electrode from inside the oven and remove.
Piezo Spark Generator replacement -
Remove all electrode wires. Remove the lock
nut and carefully remove from panel.
12v Spark Generator replacement -
Located at the rear of appliance. Remove all
electrode wires, unscrew the two retaining screws and lift off the unit.
7. Grill burner injector (No62)
Disconnect from gas supply (1). Remove appliance from housing (2).
Release the locking screw on the injector holder, disengage the grill pipe from the
control and remove the injector.
8. Oven burner injector (No65)
Open the oven door and unscrew the burner retaining screw, slide the burner to the left
and lift out. The injector is exposed to the right-hand side of the cut out. Unscrew the
injector.
9. Thermocouple replacement
Disconnect from gas supply (1). Remove appliance from housing (2).
Grill burner
- Unscrew the thermocouple from the control. Unscrew the nut at the
burner.
Oven burner -
Unscrew the thermocouple from the control. Inside the oven cavity, the
thermocouple is found just above the burner on the rear wall. Unscrew the locknut and
pull out the thermocouple from the rear of the appliance.
