13
In order to match the levels of signals on different
INPUTS
of the Generation VIII, there is a menu whereby the
user can offset the level of a given
INPUT
, from that of the Master Volume. This applies only when Unity Gain is
set to
OFF
. The range is
0
to
–86
, where
0
is the default setting. If the offset value were to be set to
–5
, then the
output level of the currently selected
INPUT
would be 5 less than the value of the Master Volume.
Figure 11 - Front Panel Display of the Offset Level SETUP menu
Note
: If Unity Gain is set to
ON
, then the Offset Level value will be displayed as
N/A
since there can be no
volume control in a unity gain structure.
Press the
SETUP
button once to exit the menu.
Burn In
All new in-circuit devices and cables require a burn in period. The Generation VIII provides a white noise that can
be used to evenly expedite this process. Connect all component devices and cables in the system and go to the
“
Burn in signal
” menu. (
SETUP
, #
5
twice). This feature is helpful in warming up the Generation VIII circuitry if it
has been off for some time.
Figure 12 - Front Panel Display of the Burn In Signal SETUP menu
Press button #
1
and use the
LEVEL UP
/
DOWN
buttons to turn the noise signal
ON
or
OFF
. The typical burn in
time (when components are not turned completely off) is 60 to 100 hours.
Press the
SETUP
button once to exit the menu.
Remote Triggering
Figure 13 - Front Panel Display of the Remote Trigger SETUP menu
Summary of Contents for Generation VIII Series 3
Page 1: ...THETA DIGITAL Generation VIII Series 3 Owner s Manual V 2 00 Digital Done Right...
Page 11: ...4 Generation VIII Block Diagram Figure 1 Generation VIII Block Diagram...
Page 25: ...18 APPENDIXES...
Page 28: ...21 Figure 22 Example of Connections to from a Casablanca II III Digital Out Card...
