Theta Digital Casablanca III HD, Owner'S Manual

Page: 87 / 106

1 2
3
4
5
6
7
8
9 10
11
13
15
17
12
14
16
18
Remote Control Layout
1. POWER. After the rear panel MAIN POWER switch is turned on,
press this button to exit the standby mode and to put the unit into
operational mode.
2. OFF. Pressing this button will place the Casablanca III HD into
standby mode, turning off the VFD and muting all audio outputs.
3. PAGE SELECT. Chooses the unit to be controlled by this remote.
4. VOLUME UP. Raises the master volume for all outputs. Also in-
crements parameter values in most edit modes and shifts FRONT/
REAR audio in the first BALANCE menu.
5. VOLUME DOWN. Lowers the master volume for all outputs. Also
decrements parameter values in most edit modes and shifts
FRONT/REAR audio in the first BALANCE menu.
6. MUTE. Mutes all analog audio outputs except the TAPE OUT jacks.
Press again to disable muting.
7. and – . Incrementally changes the active INPUT SE-
LECT BUTTON.
8. LEVELS LEFT and RIGHT. Shifts the audio balance to the left or
right in the first BALANCE page; used to adjust the MASTER vol-
ume level when in most submenus; used to change INPUT SE-
LECT pages.
9. A-D. Sequences through input jacks assigned (mapped) to the ac-
tive INPUT SELECT button. Also toggles between menu pages.
10. SETUP. Accesses submenus for setting speaker configurations/
levels/delays, analog input levels, naming inputs, setting the display
& remote features, selecting the video type, setting options for in-
coming Dolby Digital, DTS and much more.
11. REMOTE. Activates/deactivates the REMOTE POWER jack on the
rear panel.
12. INPUTS. Individual buttons which select the desired input. Within a
function’s submenu page(s), these buttons select sub functions to
edit. When pressed, the corresponding LED on the front panel is
activated.
13. DISPLAY. Temporarily overrides the VFD display brightness level.
14. TAPE OUT. Used to route audio signals to the TAPE OUT jacks.
15. PHASE. Inverts the phase (0/180°) of all speaker outputs.
16. STATUS. Displays the current status of the Casablanca III HD on
the VFD, and on the video monitor if optional video card is installed
and video display is enabled.
17. MODE. Activates/deactivates the MODE select pages for currently
selected input.
18. BALANCE. Activates the BALANCE menus allowing a temporary balance configuration to be set in order to adjust for
different program characteristics.
Note : When operating the hand-held remote control, point it at the remote sensor on the Casablanca III HD’s front
panel. The remote control can be used 3 to 20 feet from the Casablanca III HD within 30
o
of each side of the sen-
sor. Exposing the remote sensor to direct sunlight or strong light may cause faulty operation.
87