ThermoTec LCSPI-120, Operation & Installation Manual

Page: 12 / 20

RENEWABLE HEATING & COOLING TECHNOLOGY
>After setting Timer 1 ON “hour” digit,press again to enter into Timer 1 ON “minute” digit which will
flash, then press and buttons to set value for Time 1 ON “minute” digit.
>After setting Timer 1 ON “minute” digit, press again to enter into Timer 1 OFF “hour” digit,
The setting way is same as above.
>When finish setting Timer OFF time, press again to confirm current Timer settings,and enter into Timer 2
ON/OFF settings,the operation is same as Timer 1 settings,then back to main operation interface.
>On Timer setting interface screen, press for 5 seconds to cancel current Timer ON/OFF settings.
>On Timer setting interface screen, if there is no press on any button for continuous 30 seconds,system will
automatically confirm current Timer settings and back to main operation interface(Timer memory is available
if power off.).
>On Timer setting interface screen, press to confirm current Timer settings and back to main operation
interface.
>Settings way for other groups of Timers is same as Timer 1.
>Timer 1,2 are for unit ON/OFF,Timer 3 is for return water,Timer 4 is for water refilling.
Lock and unlock buttons
>Under locked button status, press for 3 seconds,after a buzzer,button will be unlocked.
>Automatically lock buttons if there is no press on any button within 60 seconds.
Cooling mode
>Press for 5 seconds, can switch different modes:cooling,heaing
Forced defrosting
>Under unit ON status, press for 3 seconds to enter into forced defrosting.
>Press for longer time till unit turns off,3 minutes later the forced defrosting will exit.
Or if defrosting time reaching to Parameter “H5”, the forced defrosting will exit as well.
Remove error history record
>On error history query interface screen, press and for 5 seconds to remove error history records.
Reset
>Under unit OFF status, press and for 5 seconds, parameters will resume initial factory
default value
.
Page 11