Propane Gas Cylinders
• Your grill is designed to operate with one 16.4 oz. disposable
cylinder (Dot 39 Cylinder) that is 73/8” high (not included).
• The cylinder must be installed, transported and stored in an
upright position and should not be dropped or handled
roughly.
• When the appliance is to be stored indoors, the propane gas
cylinder must be disconnected from the appliance.
• When the propane gas cylinder is not disconnected from the
appliance, the appliance and cylinder must be stored outdoors
in a wellventilated space.
• The cylinder should never be transported or stored where
temperature can reach 125°F (51°C).
• Cylinders must be stored outdoors out of the reach of children
and must not be stored in a building, garage, or any other
enclosed area.
Do
not attempt to refill any 16.4 oz. disposable fuel cylinders.
Leak Testing Your Grill — IMPORTANT!
How to leak test your grill:
If growing bubbles appear, there is a leak. Retighten
connection and repeat steps 1 and 2.
• During leak test, keep grill away from open flames or sparks
and do not smoke. Grill must be leak tested outdoors in a well
ventilated area.
• Leak test must be repeated each time propane cylinder is
replaced or after storage.
Materials needed include a clean paint brush and a 50/50 soap
and water solution. Use mild soap and water.
1. Be sure control knob on regulator is in
position.
2. Brush soapy solution onto connection between cylinder and
regulator.
If you cannot stop a leak, remove cylinder from regulator and
check for damaged threads, dirt and debris on regulator and
cylinder.
Also check to see if anything is obstructing
the flow of gas at regulator and cylinder openings. Remove any
obstruction that may be found and repeat leak test.
Do not use
household cleaning agents.
OFF
If threads are damaged on either regulator or
cylinder, replace.
Use and Care
• If grill does not light on first try, turn control knob to
OFF position, wait 5 minutes and try procedures 1
through 5 again.
• If flame goes out while in use, turn control knob to
OFF, remove or raise lid and wait 5 minutes to repeat
lighting procedures.