Thermopatch HS-21-SQR Penguin, Manual, Page: 12 / 30

thermopatch.com
12
• Turn the excenter screw from left to right for
a lighter setting.
• Turn the excenter screw from right to left for
a heavier setting.
9. Technical annexes
9.1 Faults:
1. Press does not warm up, the time does not count down or the temperature does not rise
on the display:
• The machine is not connected to the electricity grid. Put the plug of the power cable in
an earthed socket and switch the machine on.
• The machine is not connected. Set the switch at the back of the machine to the ON
position.
• A switch has broken or a connector has come loose. Please contact the service
department.
2. Press does not warm up:
• The sensor is defective. Please contact the service department.
• The safety thermostat has been activated. Please contact the service department.
• The heating element is defective. Please contact the service department.
3. The press time cannot be set correctly:
• The electronics are defective. Please contact the service department.
• There is no signal at the end of the press time.
• The timer or the beeper is defective. Please contact the service department .
• The electronics are defective. Please contact the service department.
4.
Press does not close or is difficult to open:
• Adjust the excenter screw (A) and close the machine. By turning the eccentric, the
momentum for opening can be easily adjusted. Turn clockwise for a lighter setting and
counter clockwise for a heavier setting.
A A
Error codes:
Below you will find an overview of the error codes which appear on the display. If these
error codes occur, please contact your Thermopatch supplier.
• Error code 1: Breakage of wire in PT1600 (resistance high)
• Error code 2: PT1600 short circuit (resistance low or 0)
• Error code 3: Heating element is broken down.
• Error code 4: Electronics are broken down.
9.2 Replacement parts
The following parts should be replaced regularly:
Silicone rubber sealing pad 120 x 120 mm square
SPAPEN-21026
Self-adhesive teflon cover 120 x 120 mm square SPAPEN-21316