Remove insulation from ends of bus wires.
13.
Apply a liberal amount of RTV sealant to cable. Slide
boot onto the end of the cable.
14.
Slide green/yellow ground sleeve over twisted braid.
15.
Push excess cable back through expediter. Tighten cap
securely. Tape cable expansion loop to pipe.
16.
Using dimple molded into side of junction box base
to locate center of hole, drill for user supplied power
connection fittings per manufacturer’s
recommendations (if necessary).
17.
Mount junction box base on expediter. Make sure to
align slots to properly orient junction box base.
18.
Installation Instructions
7
8