Thermomedics Caregiver PRO TF-300, Instructions For Use Manual, Page: 9 / 16

P|9
Room temperature mode measures the temperature of the
room in which the thermometer is located. Allow 20 minutes
for the thermometer to adjust to abrupt changes in room
temperature.
Setting SURFACE or ROOM Modes
1. If Caregiver® is powered off (blank display), press
POWER
.
2. Press and hold
MODE
for 5 seconds. The currently set Mode
(Body, Surface or Room) will flash.
3. Press
MODE
repeatedly to cycle to the next mode -
SURFACE/ROOM/BODY.
4. Press
POWER
key to exit this function and display the
temperature in the desired Mode.
5. Caregiver will remain in the chosen Mode with each press
of the POWER button until it powers off after 30 seconds.
It will then revert back to BODY Mode.
Setting Date and Time
This setting is only necessary at initial setup and when the
batteries are changed.
1.
If Caregiver is powered off (blank display), press
POWER
.
2. Press and hold
SET
for 5 seconds. The currently set date will
display and the “months” digits will flash.
3. Press
MODE
repeatedly to increase the month by 1 or
press·
o C/ o F
repeatedly to decrease the month by 1.
4. Press
SET
to change the DAY. The “day” digits will flash.
5. Press
MODE
repeatedly to increase the day by 1 or press
o C/ o F
repeatedly to decrease the day by 1.
6. Press
SET
to change the YEAR. The “year” digits will flash.
7. Press
MODE
repeatedly to increase the year by 1 or press
o C/ o F
repeatedly to decrease the year by 1.