Wiring
IMPORTANT WARNING AND SAFTEY INSTRUCTIONS ATTENTION USER/INSTALLER:
This guide contains important information about the installation, operation and safe use of this product.
DANGER! RISK OF ELECTRIC SHOCK, WHICH CAN RESULT IN SERIOUS INJURY OR DEATH. Before
attempting installation or service, ensure that all power to the circuit supplying power to the system is
disconnected / turned off at the circuit breaker. The pump connection should be performed by a licensed
electrician, and must conform to all national, state, and local codes.
After installation your app on your cellphone, you have a simple wiring for connecting your Pump to your
Wifi device.
You have the following items in your box:
2 x fork connectors for connecting hotline wires to your SSR outputs 1,2
2 x easy connectors for connecting the ground wires together and neutral wires together
2 x O-ring glands for sealing and tightening the cable (if the diameter of cable is smaller than box gland’s
holes)
1 x White Silicon sealing strip for water proofing your box (or it is installed on your box cap)
For easy wiring, you need to cut your water pump cable in 2 halves. Bring out the hot line, neutral and
ground wires of each cut end. Insert the cables to the box (through the glands) and then connect the
hotline of one half to pin 1 of SSR and the hotline of the other half to pin 2 of SSR (110V US hotline is black
wire and 220V EU hotline is red wire). Then connect the ground wires of both halves with easy
connectors together and Neutral wires with easy connectors together too. For more clarification please
check the following diagram. If you use your box outdoor, you need to make sure that all connections and
also plugs and sockets are completely sealed.
