5
•
Installation
Vanquish Diode Array Detectors (VH-D10) Operating Manual
Page 71
3. Connect the capillary to the flow cell inlet.
Figure 21: Capillaries properly connected in the detector
5.6.4.2
Connecting the Detector Waste Line
Preparations
1. See
section 5.6.4 Flow Connections to the Flow Cell, page 67
2. On the system base, route the detector waste line through the
dedicated detector waste outlet in the base to waste. Follow the
instructions in the
Vanquish System Operating Manual
.
Follow these steps
1. On the flow cell outlet, connect the waste line. Make sure that you
secure the waste line appropriately in the capillary clips on the
detector front panel.
2. On the partition panel, route the waste line through the top recess.
Make sure that you use the suitable partition panel plug.
3. From the Vanquish system base, route the waste line upward to the
detector, through the tubing guides of the system modules below
the detector.
Make sure that the waste line has been connected to the waste
container and routed through the system base as described in the
Vanquish System Operating Manual
.
Summary of Contents for Vanquish VH-D10
