ThermoFisher Scientific Vanquish VC-D50, Operating Manual

Page: 49 / 188

5 • Installation
Fluorescence Detectors (VC-D50, VC-D51, VF-D50, VF-D51)
Operating Manual Page 49
5.2 Installing the Device
The Vanquish system is installed and set up by a Thermo Fisher Scientific
service engineer, including all modules and options or parts shipped with
them. The service engineer checks that the installation is correct and
that the Vanquish system and modules operate as specified. The
engineer also demonstrates the basic operation and main features.
If personnel other than a Thermo Fisher Scientific service engineer
installs the device, follow the steps below.
NOTICE
The device is part of the Vanquish system. Therefore, follow the order
for installing the system modules as described in the
Vanquish System
Operating Manual .
1. Pay attention to the safety guidelines and observe all site
requirements. See Safety Guidelines for Installation ( } page 48) and
Site Requirements (
}
page 51) .
2. Set up the device hardware. See Setting Up the Hardware
( } page 54) .
3. Set up the flow connections. See Setting Up the Flow Connections
( } page 64) .
4. Turn on the device. See Turning On the Device (
}
page 86) .
TIP
Before turning on the power to a Vanquish system module for the first
time, verify that the chromatography software is installed on the data
system computer. When the power is turned on, the required USB
drivers are automatically found and the Windows™ operating system
can detect the device.
5. Set up the device in the software. See Setting Up the Device in the
Software (
}
page 87) .
6. Perform a wavelength calibration and wavelength validation.