ThermoFisher Scientific QuantStudio 12K Flex OpenArray AccuFill System, User Manual

Page: 26 / 103

2.
In the Plate format section, select a value.
The values in the Plate format section depend on the plate format that was chosen in step 1.
The Plate format is not displayed if 3-sample fixed panel or 4-sample fixed panel was chosen in
step 1.
3.
In the Sample input type section, select the type of plate.
•
96-well
• 384-well
4.
In the Pipettor section, select a type of pipette.
•
Fixed
•
Adjustable
The number of sample input files displayed in the Add your input sample files—optional section
depends on the selections made in the previous steps.
5.
(Optional) In the Add your input sample files—optional section, click Choose File , navigate to
the location of the CSV file, then select the file.
The format of the sample plate file is validated. For the requirements of the sample plate file, see
“File formats”
on page 11 .
The name of the file is displayed in the Select file field.
6.
Repeat step 5 for each CSV file.
Note:
Only one CSV file is imported if 384-well was selected in step 3.
7.
Click Next .
The Map plates pane is displayed.
If 96-well was selected in step 3, proceed to “Map a 384-well plate from 96-well plates” on page 30 .
If 384-well was selected in step 3, proceed to “Set up a 384-well sample plate” on page 35 .
Chapter 5
Map plates
Configure the experiment design to map the plates
5
26
QuantStudio ™ 12K Flex OpenArray ™ AccuFill ™ System User Guide