ITA/ITAS-US
40.020.945 - rev. 04 - 2011
7
English
1
SAFETY INSTRUCTIONS
1.1
Pictograms in this manual
1.2
Pictograms on the heater (fig. 2)
A Pump pressure
1.3
Use in conformity with destination
The heater is designed for use on
construction sites, in poultry houses,
workshops, storage rooms, warehouses,
greenhouses and polyurethane tunnels and
to dry agricultural products and bulbs.
1.4
Use this product for the purpose it
was intended for
The convector heater was designed for use
indoors and outdoors. The heater can be
used for the heating of tents, building sites,
showrooms, sports halls, storage sheds,
workshops, round-the-clock projects,
warehouses, greenhouses, polytunnels,
spray arrangements, and for the drying of
agricultural produce and bulbs.
1.5
General instructions
Caution
A caution shows a danger that can
cause damage to the equipment.
Warning
A warning shows a hazard that can
cause death or serious injury.
Warning
When working on the heater for
maintenance or repair works always
disconnect the electric power!
Hot
Some surfaces are hot! Wait until
these parts are cooled down
sufficiently before maintenance is
carried out.
Suggestions and advice for
conducting the relevant tasks or
activities more easily.
Caution
If the heater will be installed indoors,
make sure that there is proper
ventilation in the room. Make sure
the flue gas can only flow to an
outside source separate from the
room.
Warning
•
For all service and adjustments
contact qualified, competent and
authorized persons.
•
Make sure to always follow the
local standards and guidelines as
well as the local requirements.
•
Make sure to read this manual
carefully before using the
convector heater.
•
Keep this document near the
convector heater.
•
Follow the procedures described.
•
Do not lean on the convector
heater.
•
Do not tamper with the heater.
Adjustments may only be made
by specially trained personnel.
•
Do not operate the unit near
combustibles.
•
Keep at least 7 ft away from the
exhaust opening of the convector
heater.
•
Make sure there is sufficient air
for proper combustion.
•
Make sure there is no highly
flammable material near the
convector heater.
