31
..... Additional setup menus within the DIAGNOSTICS submenu
3.
Reynolds Number/Profile Factor
display (92): Displays the Reynolds number and flow profile factor
currently being used by the flowmeter. The flow profile factor is calculated by the flowmeter and used
to determine the effect of the flow profile on mean measured fluid velocity (Figure 3.17-C, below).
4.
Current Loop Output
display (93): Displays values of the current in mA that the flowmeter is presently
providing to the current loop output (Figure 3.17-D, below).
5.
Software/Firmware Revision Level
display (94): Displays the software (
SOFT VERS.
) and firmware
(
FPGA VERS.
) versions installed in the flowmeter (Figure 3.17-E, below).
F
IGURES
3.17-A
THROUGH
3.17-E (
LEFT
TO
RIGHT
,
TOP
TO
BOTTOM
)
3.18 Additional Setup Menus Within the PRINT Submenu
*Not included in the Quick Setup configuration
Following are instructions on how to configure the optional external thermal printer. To begin, ensure the
printer cable is connected to the printer port on the upper left of the flowmeter’s control panel.
1.
Print Log Setup
menu (96): Use this menu to configure the printer to print out flow data at a preset
interval and/or whenever an alarm activates. Printed flow data include data from all enabled totalizers.
Flow data are printed in minimum, maximum, and average flow rates. Minimum and maximum flow
rates automatically reset at the end of each print period. The average flow rate is the average over the
print interval. To configure the printer:
a.
Access Menu 96
(Figure 3.18-A, page 32)
.
b.
Select an option from the following:
1.
NONE
: Disable printer
2.
FLOW
: Print flow data at a preset log interval
3.
ALARM
: Print flow data when an alarm activates
4.
BOTH
: Print flow data at a preset log interval
and
when an alarm activates
c.
If you select
FLOW
or
BOTH
, press the
DOWN ARROW
to set the print interval
(Figure 3.18-B,
page 32)
.
