Thermo Scientific Vanquish VH-P10-A-02, Operating Manual

Page: 57 / 238

5 • Installation
Vanquish Pumps (VH-P10-A-02) Operating Manual Page 57
No. Description
6 Digital I/O ports (Dig I/O)
Allow exchange of digital signals with external instruments
Each digital I/O port provides one input, one relay output, and one bidirectional
input/output. For connection and pin assignment information, see
section 11.2,
page 230 .
7 USB hub ("A" type connector)
Allows connection to other modules in the Vanquish system
8 USB (Universal Serial Bus) port ("B" type connector)
Allows connection to other modules in the Vanquish system or the computer
on which the data management system is installed, such as the Chromeleon
software
TIP Thermo Fisher Scientific recommends using the USB ports only as
described above. If the USB ports are used for any other purpose,
Thermo Fisher Scientific cannot ensure proper functionality.
Connecting the Pump
NOTICE
•
Never use defective communication cables. If you suspect that a
cable is defective, replace the cable.
• To ensure trouble-free operation, use only the cables provided by
Thermo Fisher Scientific for connecting the pump.
1. Place the pump in the system as required by the system
configuration. For details, refer to the
Vanquish System Operating
Manual
.
2. Connect the required interface cables to the pump.
For information about how to connect the pump to other modules in
the Vanquish system or to the chromatography data system
computer, refer to the
Vanquish System Operating Manual
.
3. Verify that the power switch on the pump is set to OFF.
4. Connect the power cord to the power-inlet connector on the pump.