6
Troubleshooting
Troubleshooting by User
Thermo Scientific
Sorvall LYNX 4000 / 6000
45
4.
Push the release cords back into the centrifuge and mount the plug.
5.
Reconnect the centrifuge once the power has been restored.
6.
Switch on the centrifuge
, this will reset the lock.
7. Press
on the touchscreen or the big key on the right corner of the centrifuge.
Troubleshooting by User
Error message appear in a red screen.
Figure 19. Example for an error message
Note
You need to pull both release cords in order to unlock both locks.
Note
If problems occur other than those listed in this table, service technician must be contacted.
Failure message
Problem with centrifuge
Possible causes and cures
E-1 - E-97
Restart the centrifuge.
If the message appears again, inform a service
technician.
E-98
The centrifuge cannot be operated.
The run does not start or the centrifuge
brakes and ends the run.
Imbalance detected.
Check the load placed in the rotor.
Check that the bolts of the rotor are well greased.
Restart the centrifuge.
If the message appears again, inform a service
technician.
E- 99
Restart the centrifuge.
If the message appears again, inform a service
technician.
Summary of Contents for Sorvall LYNX 4000
Page 18: ...1 Introduction and Description 8 Sorvall LYNX 4000 6000 Thermo Scientific ...
Page 28: ...2 Before Use 18 Sorvall LYNX 4000 6000 Thermo Scientific ...
Page 34: ...3 Control Panel 24 Sorvall LYNX 4000 6000 Thermo Scientific ...
Page 71: ...Thermo Scientific Sorvall LYNX 4000 6000 61 Index ...
