Ramsey Oretronic IV Tramp Metal Detector REC 4479C
Page 40
Figure 3
–
5b. Settings screen, scrolled to bottom
Belt Speed
This setting is only displayed if the Speed Sensor option is disabled. Enter into this control the typical
operating speed of the belt. This value will be used to the metal detection capability and marker timing. The
allowable range is 5 to 1800 fpm (0.025 to 9.0 m/s).
Material Code
The material code determines the timing of the pulse and detection mechanism described in Figure 1-5, in
order to optimize the detection for different materials. The selection range is 1 through 7.
Operating Frequency
This setting changes the scanning frequency (A or B) to improve detection.
Reverse Direction
This setting reverses the direction of the detection algorithm. It does not actually change the direction of the
belt.
Marker Distance
Edit this field to define the distance from the coil to the marker device. If there is no speed sensor, the system
calculates this distance based on time and the Belt Speed setting. If a speed sensor is installed and enabled,
the distance is based on calibrated speed pulses. The allowed range is 4.9 to 328.1 feet (1.5 to 100.0 meters).
