Thermo Scientific LevelPRO, User Manual

Page: 41 / 128

Chapter 4
Operation
Communication
Setup
Communication with the LevelPRO detectors is via an RS232 single-drop serial port,
an RS485 multi-drop serial port, a USB cable, or an Ethernet cable from a PC running
EZ Cal II software. Once the detector is set up, the primary measurement (level) can
be viewed on the display and on the EZ Cal II software.
To communicate with the detector from a PC, the PC must be running the Thermo
Scientific EZ Cal II software. To access the Communication Setup screens using only
the detector display, see
Figure A-18 .
Com A / Com B
(RS232)
The serial port on a PC can connect directly to the detector’s RS232 serial port (Com
A or Com B).
To configure the Com A and Com B ports, select Communication Setup from the EZ
Cal II menu tree.
Figure 4-1. Communication Setup, Com A / Com B
Thermo Scientific LevelPRO User Manual 4
-
1