Thermo Scientific GENESYS 10S Vis, User Manual

Page: 39 / 134

Thermo Scientific GENESYS 10S Vis User Guide 31
6
Managing Stored Tests
The instrument uses test method files containing the values for all parameters needed to run a
test, including those for cell changer alignment and installed accessories. After setting the
parameters, you can assign a unique test name and save the test. You can then restore the test
and run it without having to set the parameters again.
When you power-down the instrument, the current test is maintained by battery backup.
When you turn the instrument on again, the cell holder alignment and values for all
parameters are the same as when the instrument was last used. If you load a saved test, the
values for all parameters stored with it replace the current values of the test parameters.
Software Password
This password lets you “lock” test setups (test parameters) so they may not be overwritten or
deleted. The password also lets you remove the security so you may edit the test parameters.
See the Lock/Unlock section for more information on locking a test.
Password: 4363797
Naming a Test
When saving a test, specify its file name using up to eight alphanumeric characters.
Y To name a test
1. After setting the test parameters, highlight Test Name and press Enter .
Note This password cannot be changed.
Note Tests stored on a USB memory device cannot be locked or unlocked.