To Insert battery plate,
align the small taps into
the guide ribs on the
housing
To lock the battery plate,
press down and slide in
To Release the battery plate,
Push away this tap.
Battery Plate Unlock position
Battery Plate locking position
To Insert battery plate,
align the small taps into
the guide ribs on the
housing
To lock the battery plate,
press down and slide in
To Release the battery plate,
Push away this tap.
Battery Plate Unlock position
Battery Plate locking position
To Insert battery plate,
align the small taps into
the guide ribs on the
housing
To lock the battery plate,
press down and slide in
To Release the battery plate,
Push away this tap.
Battery Plate Unlock position
Battery Plate locking position
Figure 1: Removing Battery
cover
Figure 2: Push to unlock
Figure 3: Align tabs
Figure 4: Push down to lock
Figure 5: Battery plate unlock position
Figure 6: Battery plate lock position
To Insert battery plate,
align the small taps into
the guide ribs on the
housing
To lock the battery plate,
press down and slide in
To Release the battery plate,
Push away this tap.
Battery Plate Unlock position
Battery Plate locking position
To Insert battery plate,
align the small taps into
the guide ribs on the
housing
To lock the battery plate,
press down and slide in
To Release the battery plate,
Push away this tap.
Battery Plate Unlock position
Battery Plate locking position
2
Elite PCTS Tester Operating Instructions
This instruction manual is applicable for Elite PCTS Tester.
Replacing the Batteries
The Elite PCTS tester uses four AAA 1.5 V batteries.
1. To remove the battery cover, See Figure 1. Clear the front catch and then the back
catch, before sliding the cover off.
2. To remove the battery plate, push the center tab towards the front of the tester as
show in Figure 2. Once unlocked, remove the plate to access the batteries.
3. Invert the tester upside down to remove the batteries. Each side uses two
AAA batteries. Orient each battery with positive terminal facing downward.
4. To lock the battery plate, align the small taps into the guide ribs
on the housing and then press down. See Figure 4.
Getting Started
The Elite PCTS tester has been factory calibrated and usually works well out of the box. However, after extended
periods of non-use, it is best to remove the sensor cap and soak the sensor in warm tap water for 10 minutes or so.
Prior to taking the measurements, periodic calibration with certified standards is recommended for best accuracy.
Measurement Parameter Setting
1. Press
to power the tester on.
2. Press to enter setup window. Press
to select Measure. The display shows pH, Cond, TDS and Salinity.
3. Scroll down by pressing to toggle between pH, Cond, TDS and Salinity. Press to select pH.
4. The display shows the selected measure with a
.
Settings
Temp Set
Reset
Key Info
Scroll
Accept
EXIT
Cond
TDS
Salinity
pH
Measure
pH