To Insert battery plate,
align the small taps into
the guide ribs on the
housing
To lock the battery plate,
press down and slide in
To Release the battery plate,
Push away this tap.
Battery Plate Unlock position
Battery Plate locking position
To Insert battery plate,
align the small taps into
the guide ribs on the
housing
To lock the battery plate,
press down and slide in
To Release the battery plate,
Push away this tap.
Battery Plate Unlock position
Battery Plate locking position
To Insert battery plate,
align the small taps into
the guide ribs on the
housing
To lock the battery plate,
press down and slide in
To Release the battery plate,
Push away this tap.
Battery Plate Unlock position
Battery Plate locking position
Figure 1: Removing battery cover
Figure 2: Push to unlock
Figure 3: Align tabs
Figure 4: Push down to lock
Figure 5: Battery plate
unlock position
Figure 6: Battery plate
lock position
To Insert battery plate,
align the small taps into
the guide ribs on the
housing
To lock the battery plate,
press down and slide in
To Release the battery plate,
Push away this tap.
Battery Plate Unlock position
Battery Plate locking position
To Insert battery plate,
align the small taps into
the guide ribs on the
housing
To lock the battery plate,
press down and slide in
To Release the battery plate,
Push away this tap.
Battery Plate Unlock position
Battery Plate locking position
2
Elite ORP Tester Operating Instructions
This instruction manual is applicable for Elite ORP Tester.
Installation and Uninstallation of the Battery
The Elite ORP tester uses four AAA 1.5 V batteries.
1. To remove the battery cover, See Figure 1. Clear the front catch and
then the back catch, before sliding the cover off.
2. To remove the battery plate, push the center tab towards the front of the tester
as show in Figure 2. Once unlocked, remove the plate to access the batteries.
3. Invert the tester upside down to remove the batteries. Each side uses two
AAA batteries. Orient each battery with positive terminal facing downward.
4. To lock the battery place, align the small taps into the guide ribs on the
housing and then press down. See Figure 4.
Getting Started
The Elite ORP tester has been factory calibrated and usually works well out of the box. However, after extended
periods of non-use, it is best to remove the sensor cap and soak the sensor in warm tap water or ORP buffer for
10 minutes or so. A brief rinse with deionized (DI) water is OK, but avoid soaking or storing in deionized water as this
will shorten ORP electrode life. Prior to taking the measurements, periodic callibaration with certified standards is
recommended for best accuracy.
Temperature Settings
1. Press
to enter setup window. Press
to select Temp set. The display shows Set °C/°F and Temp Cal.
2. Press
to select Set °C/°F. The display automatically shows °C
and
°F.
3. Scroll down by pressing to toggle between °C
and
°F
.
4. Press
to select a temperature unit. The display shows the selected temperature setting with a .
English
Settings
Reset
Key Info
Scroll
Accept
EXIT
Temp Cal
°C
°F
°C
Temp Set
Set °C/°F
