Thermo Scientific Dionex, Operator'S Manual

Page: 148 / 228

Dionex Integral Systems Operator’s Manual
136
Doc. 065250-06 03/2020
10.8 Replacing an SP Solenoid Valve
These instructions apply to solenoid valves installed on the SP panel.
1. Turn off the SP power.
2. Disconnect the power cord.
3. Disconnect each liquid line on the valve
to be replaced (see Figure 10-10 ) and
remove any fitting plugs installed in the
valve ports.
Figure 10-10. Solenoid Valve
(SS Valve Shown as an Example)
4. Follow the instructions in Section 10.7 to access the main SP electronics
board.
5. The solenoid valve cables are plugged into connectors in the upper-left corner
of the board (see Figure 10-11 ).
Figure 10-9. SP Horizontal Enclosure: Service Door Open