Thermo Scientific dionex ic pure water, Operating Instructions Manual

Page: 102 / 128

| Maintenance
92
|
Dionex IC Pure system Thermo Scientific
Chapter 13
Replacing the 0.2 μ m final filter
7 Insert the ultrapure cartridge back into the unit (see “Changing the
ultrapure cartridge” on page 79). If an optional pretreatment car-
tridge is used, install it also in the unit (see “Replacing the pretrea-
ment cartridge (optional)” on page 80).
8 Switch the system on. If the unit is connected to an external 20 L
tank with level control, open the supply of feedwater.
9
c. After entering the code push the “Menu and UV“ button
simultaneously. The display shows “UV Menu“.
d. Push the “Menu“ button repeatedly until new UV-lamp
appears and press enter to confirm. The Display shows then
“Please wait“.
Step Action
Figure
Note For this action you must have a Level 3 code. Refer to
section “Entering a Code number” on page 71 to read where to
find this code and how to enter it.
Note The system sets the operating hours counter of the
UV-lamp back and saves the new values by an automatically
calibration.
a.)
b.)
Step Action Figure
1 Rotate the exhausted or clogged sterile filter in a
clockwise position to remove it.
2 Unpack the new sterile filter and screw it into the
bottom 1/4“ thread on the sampling tap.
1/4“ thread
0.2 µm final filter