Bottle/Tube Roller 1-3
Thermo Scientific
Section 1
Unpacking and Installation
4. Installation for stacked units
For stacking two units, optional accessories are necessary. The two units
can be stacked together.
a. Loosen the inner hexagon screw on the bottom of the unit, pull
the round head of the inner hexagon screw out as the arrow
direction (see Figure 1-4) until a support base is pulled out (see
Figure 1-5), then tighten the inner hexagon screw. Repeat Step a
for other three support bases to be extended.
b. Locate the four stainless pillars in the
stacking accessories. Screw the head
with the M5 screw thread into
extended support base in Step a (see
Figure 1-6).
c. Screw the other head with M4 screw
thread into support base hole of the
stacked unit and fasten the knob (see
Figure 1-7). Repeat Step c to install
remaining three support bases (see Figure 1-8).
Installation
(continued)
Figure 1-7.
Tighten Knob after Installation
Figure 1-8.
4 Pillars into Support Bases
Figure 1-6.
Pillar
Figure 1-4.
Loosen Inner Hexagon Screw
Figure 1-5.
Support Base Out
