Thermo Scientific 5028i, Instruction Manual

Page: 46 / 330

Installation
Setup
2-10 Model 5028
i
Instruction Manual Thermo Fisher Scientific
One limiting factor when siting the Model 5028 i is placement within
a standard 19-inch rack mounting. Future planning should be made
to reserve the topmost rack mounting position available due to the
vertical positioning of the sample tube directly from the roof into the
top of the Model 5028 i . In addition, modification to the rack cabinet to
accommodate the vertical tubing connection also needs to be considered
prior to installation. For more information, see Chapter 9 “ Optional
Equipment ”.
Review the following installation steps prior to field installation.
Once all height requirements are established, the following steps are
usually taken to complete the installation.
1. Open the front door of 5028
i and inspect for proper filter tape
installation.
2. Place 5028 i unit in place of intended operation.
3. Attach the insulated heater tube assembly to the 5/8-inch OD tubes
on top of the 5028 i ( Figure 2–5 ).
To Rear Panel 5028i “CHA
HEATER” or
“CHB HEATER”
Tubing Connector
Fasten Nut
Figure 2–5. Heater Assembly
4. Attach a second tubing connector to the top of the heater tube.
Rack Mounting Option
Monitor Installation