![background image](http://html1.mh-extra.com/html/thermo-king/t-1000r/t-1000r_maintenance-manual_1104339180.webp)
Engine Maintenance
9-42
Engine/Electric Motor (Jackshaft) Belt - T-500R/T-Dairy
The engine/electric motor (jackshaft) belt is a 3V belt. A static belt tensioner keeps the belt at the proper tension. Use the
following procedure to replace this belt or adjust the belt tension.
1. If replacing the belt, remove the electric motor (jackshaft)/compressor belt.
2. Loosen the locknut on the restraining mount (snubber) until the chain is loose.
3. Loosen the pulley mounting bolt enough to allow the adjusting bracket to slide, but not enough to allow the pulley to tilt.
4. Turn the adjusting bolt counter-clockwise until the belt is loose. If not replacing the belt go to step 7.
5. Remove the old belt and note how it fits on the pulleys.
6. Install the new belt. Make sure it fits on the pulleys correctly.
7. Take a straight edge, place it against the side of the muffler can and mark the frame as shown below. This is the unloaded
engine position.
Mark Frame
8. Turn the adjusting bolt clockwise to make the pulley descend and tighten the belt until it is at approximately 10 Hz lower than
the correct belt tension setting using the frequency gauge P/N 204-1903 on the top span. This will pull the engine towards the
belt. See “Specifications” for the correct belt tension settings.
Note: When using the frequency gauge P/N 204-1903, place the probe near the belt with the LED shining on the belt. Pluck
the belt with a metal tab as shown below to get an accurate reading. Take three readings and average them.
1.
Probe
2.
Metal Tab
Using Frequency Gauge P/N 204-1903
1
2
Summary of Contents for T-1000R
