Thermo King SR-2 SmartReefer2, Diagnostic Manual

Page: 79 / 431

Section 3 – SR-2 Software Description
Cycle Sentry Mode
Micro Rev
All
HMI Rev
All
Choices Off or On
Factory Set On
Exceptions
Description Cycle Sentry Mode automatically
starts the unit when cooling, heating or defrosting is
required and stops the unit when all requirements
are satisfied. In Diesel Mode operation the unit also
starts and stops as necessary to keep the engine
warm and the unit battery charged. In Electric Mode
operation the unit starts and stops as necessary to
keep the unit battery charged.
This feature allows Cycle Sentry Mode to be turned
On or Off for the selected range. If both Cycle
Sentry and Continuous are turned On, then they are
selectable using the Mode key or the Main Menu on
the HMI Control Panel.
If Cycle Sentry is set On and Economy Mode is set
Off, the Cycle Sentry OptiSet custom features are
available. The Cycle Sentry OptiSet custom
features are the same for Fresh and Frozen ranges.
These features are shown on the following pages.
Continuous Mode
Micro Rev
All
HMI Rev
All
Choices Off or On
Factory Set On
Exceptions
Description In Continuous Mode the unit is
started and continues to run, even if all requirements
are satisfied. This provides constant airflow over
and around the load.
This feature allows Continuous Mode to be turned
On or Off for the selected range. If both Cycle
Sentry and Continuous are turned On, they are
selectable using the Mode key or Mode Menu on the
HMI Control Panel.
If Continuous is set On and Economy Mode is set
Off, the Continuous OptiSet custom features are
available. The Continuous OptiSet custom features
are different for Fresh and Frozen ranges. They are
also different between ETV and non-ETV units.
These features are shown on the following pages.
3-29
31 January 2005