Model 3980 and 3986 Incubators _________________________________Installation/Start-Up
2-10
12.
Press the display key once
13.
Turn OFF the main power switch.
14.
Remove the 982 controller module(s) by pressing in the four retaining tabs, two on the right
side, two on the left side. (Refer to Figure 2-6) Pull the controller module out by gently
rocking it from side to side.
15.
Looking at the top and left side of the controller module, locate the red DIP switches
indicated in Figure 2-7. Use your fingernail or a small screwdriver, to turn
on
SW 2 by
moving the white toggle towards the rear of the module as shown.
16.
Return the controller into its frame and firmly press on the top and bottom of the bezel until
all four locking tabs “click” into place.
17.
Turn ON the main power switch.
18.
Looking at the top and left side of each controller
module, locate the red DIP switches indicated in
Figure 2-6.
19.
With a fingernail or small screwdriver, turn off SW 2 by
moving the white toggle towards the front of the module as shown. SW 2 is the top switch
when looking at the module from the side.
20.
Looking at the back of the module, set all three of the DIP switches at the bottom of the
chassis to the ON position (up as shown in Figure 2-8).
21.
Install the modules into their locations on the front panel and press on the top and bottom of
the bezel until all four locking tabs “click” into place.
22.
Restore electrical power to the unit.
Press
Press
S id e V iew
Figure 2-6
