24
5
If the water cooler will not be used for a extended period of time, if you move it or if
you have to ship it, follow these instructions:
1. Disconnect the unit.
2. Remove the water bottle from the cooler. Even if the bottle is not empty,
the splashfree cap will close when the bottle is removed. This way, no
water will be spilled.
3. Empty the cooler completely using the two faucets.
4. Complete emptying the hot water reservoir (hot water option only)
through the drain situated in the back of the unit. (see fig. #10)
5. Clean the unit following the instructions given in the section Cleaning and
maintenance.
6. Dry the water cooler thoroughly.
7. Reinstall the different parts in their appropriate places.
8. Do not carry the water cooler by the faucets because that might cause
damage to the faucets and/or the joints and thus cause leaks.
9. Always transport or store the water cooler in a vertical position.
STORING AND SHIPPING
1. Do not connect the unit immediately after moving it. Wait for at least one
hour.
2. Do not place the unit close to a heating device or in direct sunshine. (see
fig. #1)
3. Fill the water reservoir with bottled water only.
4. Never keep the unit in a horizontal position, not even for storing or
shipping.
5. DISCONNECT THE UNIT WHEN IT IS WITHOUT WATER FOR A CERTAIN
PERIOD OF TIME.
6. Do not immerse the unit.
7. In order to avoid any risk of electric shock or fire, connect the water
cooler directly into a 120V AC (or 220V AC) grounded outlet.
8. Do not pinch, tie or twist the cord set.
9. Do not unscrew the faucets or the upper part of the faucet if the unit
is filled with water.
SAFETY INSTRUCTIONS
NOTE: If you are using the Thermo Concepts cap
offered as an option, read the following steps:
Step 1: Installation of the cap
Make sure that the cap is in its unlock position. Push downwards
firmly on the cap until you hear and/or feel a snap. Thump down
on cap to ensure maximum overlap.
Step 2: Securing cap
Turn the top portion of the cap to the right while holding
the lower portion in place.
INSTALLATION AND MAINTENANCE OF THE UNIVERSAL NO-SPILL
Thank you for purchasing a Thermo Concepts water cooler.
Please read the following instructions carefully.
WARNING
The screw-in base has been pre-installed in our plant to fit most bottles.
To test for proper installation, please follow the instructions below.
Installing and adjusting the no-spill
Step 1: Make sure that the cap (supplied with the
bottle or optional cap described below) is
fitted securely onto the bottle.
Step 2: Reverse the no-spill on the bottle and push
downwards firmly.
Step 3: Turn screw-in base clockwise.
Step 4: Stop when the cone portion of the no-spill
moves upward. Leave a small gap (+or-1/8'')
between cone and bottle.
No-spill maintenance
All parts will withstand dishwasher use. We recommend that
small parts be put in the top rack of the dishwasher.
NOTE: The filter cartridge should not be put in
dishwasher.
OPTIONAL
PART
