THERMEx palermo vertical 810, Instructions Manual

Page: 16 / 28

english
purchased in a shop selling installation materials.
a qualified installer should be commissioned to make the connection.
SETTING ThE ODOUR ABSORBER MODE Of OPERATION Of ThE hOOD
in this option filtered air returns to the room through cut outs on both sides of the top funnel.
in this setting it is necessary to install the carbon filter; installation of the air exhaust guide is
recommended.
fAN SPEEDS
the lowest and medium speeds should be used under normal conditions and with low concentra-
tion of fumes. the top speed should be used in case of high concentration of kitchen fumes, e.g.
during frying or grilling.
OPERATIONAL SAfETy
all safety instructions included in this manual shall be observed without exception!
Grease filters and active carbon filters should be cleaned and replaced according to manufactur-
er’s instructions, or more frequently in periods of intensive use (more than 4 hours a day).
if a gas cooker is used it is forbidden to leave uncovered flame. When removing pots from gas
burners set the flame to its minimum level.
always make sure that flame does not extend outside the pot. Such a situation causes undesired
energy losses and dangerous heat build-ups.
the hood should not be used for other purposes than those for which it was designed.
CONTROL PANEL
operation of the hood can be controlled by means of a combined switch.
Fig. 5
Digital display - informs about the selected speed of hood operation and/or actuation of the
switch-off timer (timer).
„+”, „-”, - motor speed selection buttons.
„t” – switch-off timer – „timer”- automatic switching off of the hood motor after preselected time
delay.
„l” – lighting on / off.
PROGRAM fUNCTION
timer function: palermo - Vertical 810 kitchen extractor hood is equipped with the option of
programming automatic switch-off of the hood fan in 10-minute intervals, up to maximum delay
of 90 minutes. “timer” is actuated by pressing „t” button during operation of the hood with the
required fan speed. the display will flash and a dot will appear indicating that the device is in the
switch-off time programming mode. then you can program the time of automatic switch-off of
the hood motor using + button, keeping in mind that the figure shown on the display multiplied
by 10-minute time interval indicates the motor switch-off delay (e.g.: 1=10 minutes, 2=20 minutes,
3=30 minutes etc.).
after setting the delay it has to be confirmed by pressing t button again. the display will stop
flashing and will show the previously set speed, and the pulsating dot will indicate that the time to
switching off of the hood motor is being counted.