THERMEx H 10 O, User Manual

Page: 6 / 94

SPECIFYING SECURITY MEASURES
Electrical safety and corrosion protection of EWH are guaranteed only if there is an
effective earthing in accordance with applicable electric installation rules and regulations.
When installing and operating EWH the following is not allowed:
•
To power EWH if EWH is not
filled with water.
•
To remove the protective cover when the power is on.
•
Use EWH without grounding.
•
To connect EWH to water supply with pressure exceeding 0.8 MPa.
•
To connect EWH to the water supply without safety valve.
•
To drain water from EWH with power switched on.
•
To use spare parts not recommended by the manufacturer.
•
To use water from the EWH for cooking.
•
To use water containing impurities (sand, small stones), which might lead to EWH and
safety valve breakdown.
•
To modify design and installation dimensions of EWH brackets. .
Attention should be paid to children so that they do not play with EWH. EWH is
not intended for use by persons (including children) with limited physical, sensory
or mental capabilities, or by persons who do not know how to use the EWH, except
for cases when this happens under the supervision or instructions by persons
responsible for safety of the EWH.
INSTALLATION AND CONNECTION
All installation, plumbing and electrical works must be performed by qualified
personnel entitled to carry out relevant works.
ARRANGEMENT AND INSTALLATION
EWH installation shall be performed in accordance with marking on the housing and
the following table:
Labeling Volume Arrangement
H_O (pro)
10 - 30 l
O
– vertical, pipes down
H_U (pro) U
– vertical, pipes up
It is recommended to install EWH as close as possible to the place of hot water using
to reduce heat loss in the pipes.